research use only
Anti-HA magnetic beads kit is based on hydroxyl magnetic beads covalently coupling with high quality mouse IgG2b monoclonal antibody.
Selleck's Has Been Cited by 85 Publications
Time saving: save 15-30 min comparing with agarose beads.
Simple operation: Magnetic separation and centrifugation-free.
High protein loading capacity.
High specificity.
Anti-HA magnetic beads kit is based on hydroxyl magnetic beads covalently coupling with high quality mouse IgG2b monoclonal antibody. With high loading of HA-tagged protein (more than 0.6 mg protein/mL) and high specificity, it is recommended to use for co-immunoprecipitation and protein purification.
| Antibody isotype | Mouse IgG2b |
|---|---|
| Antibody purification | Protein A purified |
| Application | Co-Immunoprecipitation and protein Purification |
| Recommended volume | IP: 20 μl beads for 200 μl crude protein solution |
| Binding capacity | Minimum 0.6 mg protein eluted per ml of magnetic beads |
Store at 2-8°C for 2 years. DO NOT freeze or centrifuge Magnetic Beads.
| Problem | Possible Reason | Suggested Improvement |
|---|---|---|
| High background | Nonspecifically binding of proteins to the antibody, megnetic beads or EP tubes | Pre-clear lysate to remove nonspecific binding proteins. After suspending beads for the final wash, transfer the entire sample to a clean EP tube and then centrifugation. |
| Washing times are not sufficient. | Increase the number of washes. Increase duration time of washes. |
|
| No signal is observed. | HA tagged protein is not expressed in the sample. | Make sure the protein of interest contains the HA sequence. Prepare the fresh lysate. Use appropriate protease inhibitors. |
| Incubation times are inadequate. | Increase the incubation times. | |
| Interfering substance is present in sample. | The lysate may contain high concentrations of dithiothreitol (DTT), 2-mercaptoethanol, or other reducing agents. Excessive detergent concentration may interfere with the antibody-antigen interaction. |
If you have any other enquiries, please leave a message.