niclosamide ethanolamine SDS/MSDS (Safety Data Sheet)

3.1 Substances
Product name: niclosamide ethanolamine
CAS Number: 1420-04-8
PubChem CID: 14992
Molecular formula: C15H15Cl2N3O5
Molecular weight: 388.2 g/mol
IUPAC name: 2-aminoethanol;5-chloro-N-(2-chloro-4-nitrophenyl)-2-hydroxybenzamide

3.2 Mixtures
Not applicable (pure substance).

4.1 Description of first aid measures
Inhalation: INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to t
Skin contact: SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
Eye contact: EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
Ingestion: INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport

4.2 Most important symptoms and effects, both acute and delayed
See Section 11 (Toxicological Information).

4.3 Indication of any immediate medical attention and special treatment needed
Treat symptomatically. Contact a poison control center or physician for severe exposure.

5.1 Extinguishing media
Suitable: Water spray, dry chemical, carbon dioxide (CO2), alcohol-resistant foam.
Unsuitable: None known.

5.2 Specific hazards arising from the substance or mixture
This compound is not very flammable but any fire involving this compound may produce dangerous vapors. You should evacuate the area. All firefighters should wear full-body protective clothing and use self-contained breathing apparatuses. You should extinguish any fires involving this chemical with a dry chemical, carbon dioxide, foam, or halon extinguisher. (NTP, 1992)

5.3 Advice for firefighters
Wear self-contained breathing apparatus (SCBA) and full protective clothing.
Fight fire from upwind. Cool containers with water spray until fire is extinguished.

6.1 Personal precautions, protective equipment and emergency procedures
Wear appropriate personal protective equipment (see Section 8).
Avoid breathing dust/vapor. Ensure adequate ventilation.
Evacuate personnel to safe areas. Keep people away from and upwind of spill.

6.2 Environmental precautions
Prevent product from entering drains, waterways, or soil.
Contain spill with inert absorbent material.

6.3 Methods and materials for containment and cleaning up
SRP: At the time of review, criteria for land treatment or burial (sanitary landfill) disposal practices are subject to significant revision. Prior to implementing land disposal of waste residue (including waste sludge), consult with environmental regulatory agencies for guidance on acceptable disposal practices.

7.1 Precautions for safe handling
SMALL SPILLS AND LEAKAGE: Should a spill occur while you are handling this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then you should dampen the solid spill material with ethanol and transfer the dampened material to a suitable container. Use absorbent paper dampened with ethanol to pick up any remaining material. Seal the absorbent paper, and any of your clothes, which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)
Store in original container, preferably in locked area, away from children, food, feed.

7.2 Conditions for safe storage, including any incompatibilities
Store in original container, preferably in locked area, away from children, food, feed.
Store away from incompatible materials (see Section 10).
[Note: Specific storage temperature not available in public databases. Refer to supplier Certificate of Analysis (COA) for exact storage conditions.]

9.1 Information on basic physical and chemical properties
a) Appearance: Clonitralid is a yellow solid. Insoluble in water. (NTP, 1992)
b) Odor: No data available
c) Odor threshold: No data available
d) pH: No data available
e) Melting point/freezing point: 421 to 446 °F (NTP, 1992)
f) Initial boiling point and boiling range: No data available
g) Flash point: No data available
h) Evaporation rate: No data available
i) Flammability (solid, gas): No data available
j) Upper/lower flammability or explosive limits: No data available
k) Vapor pressure: 0.00000008 [mmHg]
l) Vapor density: No data available
m) Relative density: No data available
n) Water solubility: Insoluble (NTP, 1992)
o) Partition coefficient: n-octanol/water: Log P: No data available
p) Auto-ignition temperature: No data available
q) Decomposition temperature: No data available
r) Viscosity: No data available
s) Explosive properties: No data available
t) Oxidizing properties: No data available

9.2 Other information
Topological Polar Surface Area (TPSA): 141 Ų
Complexity: 414

11.1 Information on toxicological effects
Acute toxicity:
No acute toxicity data available.
Skin corrosion/irritation:
No data available.
Serious eye damage/eye irritation:
Causes serious eye irritation (H319).
Respiratory or skin sensitization:
No data available.
Germ cell mutagenicity:
No data available.
Carcinogenicity:
No data available.
Reproductive toxicity:
No data available.
Specific target organ toxicity (single exposure):
No data available.
Specific target organ toxicity (repeated exposure):
No data available.
Aspiration hazard:
No data available.

11.2 Additional information
Carcinogen classification:
Clonitralid
TR-091: Bioassay of Clonitralid for Possible Carcinogenicity (CASRN 1420-04-8) (1978 )
06/29/78
No Evidence
Equivocal Evidence
Inadequate Experiment
No Evidence
Under the conditions of this bioassay, there was no convincing evidence that clonitralid was carcinogenic to Osborne-Mendel rats or to female B6C3F1 mice. Poor survival of male mice did not permit an evaluation of carcinogenicity in these animals.
Data source: Hazardous Substances Data Bank (HSDB) via PubChem.

12.1 Toxicity
LC50 GAMMARUS PSEUDOLIMNAEUS 2400 UG/L/96 HR @ 21 °C (95% CONFIDENCE LIMIT 1800-3100 UG/L), MATURE, STATIC BIOASSAY WITHOUT AERATION, PH 7.2-7.5, WATER HARDNESS 40-50 MG/L AS CALCIUM CARBONATE AND ALKALINITY OF 30-35 MG/L. /70%/
LC50 ORCONECTES 25000 UG/L/96 HR @ 21 °C (95% CONFIDENCE LIMIT 19000-33000 UG/L), EARLY INSTAR, STATIC BIOASSAY WITHOUT AERATION, PH 7.2-7.5, WATER HARDNESS 40-50 MG/L AS CALCIUM CARBONATE AND ALKALINITY OF 30-35 MG/L. /70%/
LC50 PALAEMONETES 10000 UG/L/96 HR @ 21 °C (95% CONFIDENCE LIMIT 7000-15000 UG/L), MATURE, STATIC BIOASSAY WITHOUT AERATION, PH 7.2-7.5, WATER HARDNESS 40-50 MG/L AS CALCIUM CARBONATE AND ALKALINITY OF 30-35 MG/L. /70%/
LC50 PTERONARCYS 200 UG/L/96 HR @ 15 °C (95% CONFIDENCE LIMIT 130-300 UG/L), SECOND YEAR CLASS, STATIC BIOASSAY WITHOUT AERATION, PH 7.2-7.5, WATER HARDNESS 40-50 MG/L AS CALCIUM CARBONATE AND ALKALINITY OF 30-35 MG/L. /70%/
For more Ecotoxicity Values (Complete) data for CLONITRALIDE (7 total), please visit the HSDB record page.
Clonitralide's production and use as a molluscicide and piscicide will result in its release to the environment. If released to soil, clonitralide will have moderate mobility. Volatilization of clonitralide will not be important from moist or dry soil surfaces. Dissociation of the ethanolamine salt of clonitralide should produce ethanolamine and niclosamide. Based on the UV absorption spectra of m-acetoacetanilide, a structurally similar compound, the niclosamide fragment should absorb sun

12.2 Persistence and degradability
No data available.

12.3 Bioaccumulative potential
No data available.

12.4 Mobility in soil
No data available.

12.5 Results of PBT and vPvB assessment
PBT/vPvB assessment not available.

12.6 Other adverse effects
This substance is classified as hazardous to the aquatic environment.

13.1 Waste treatment methods
Waste Treatment Methods: Waste material must be disposed of in accordance with national and local regulations. Leave chemicals in original containers and do not mix with other waste. Handle uncleaned containers in the same manner as the product itself.

14.1 UN number
Not regulated as dangerous goods (research quantities typically exempt).

14.2 UN proper shipping name
Not subject to transport regulations (small quantities for research use).

14.3 Transport hazard class(es)
Not classified as dangerous goods for transport (research quantities).

14.4 Packing group
Not applicable (not regulated as dangerous goods in typical research quantities).

14.5 Environmental hazards
Marine pollutant: Yes (classified as environmentally hazardous per GHS).

14.6 Special precautions for user
Transport in original packaging. Ensure containers are tightly sealed.
For bulk or commercial quantities, consult applicable transport regulations (DOT, IATA, IMDG).

14.7 Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code
Not applicable.

15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture
US EPA / TSCA: Not available in public databases.
EU ECHA / REACH: Not available in public databases.

SARA 302 Components:
No chemicals in this material are subject to the reporting requirements of SARA Title III, Section 302.
SARA 313 Components:
This material does not contain any chemical components with known CAS numbers that exceed the threshold (De Minimis) reporting levels established by SARA Title III, Section 313.
SARA 311/312 Hazards:
Acute (short-term) health hazard
Environmental hazard

Massachusetts Right To Know Components:
This material contains components subject to the Massachusetts Right to Know Act. See Section 2 for hazard classification.
Pennsylvania Right To Know Components:
This material contains components subject to the Pennsylvania Right to Know Act. See Section 2 for hazard classification.
New Jersey Right To Know Components:
This material contains components subject to the New Jersey Right to Know Act. See Section 2 for hazard classification.

California Prop. 65 Components:
This product does not contain any chemicals known to the State of California to cause cancer, birth defects, or any other reproductive harm.

Other regulatory listings:
- FIFRA Requirements: Classified for restricted use, limited to use by or under the direct supervision of a certified applicator. Clonitralid formulated as wettable powders 70% and greater are restricted for all uses. The criterion influencing the restriction is acute inhalation toxicity.
Classified for restricted use, l

15.2 Chemical safety assessment
A chemical safety assessment has not been carried out for this substance.
For research-use-only compounds, no CSA is required under REACH Annex I.

Revision Date: 2026/09/08
Further Information: The information provided is believed to be correct but is not exhaustive and should be used only as a guideline based on current knowledge. It does not represent a guarantee of the properties of the product. Selleck Chemicals Corporation and its Affiliates shall not be held liable for any damage resulting from handling or contact with the product.